Installation – Kenmore 70089 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
Figure 22. Installing Outer Case in Window
1. Indoor sash
2. Top rail
3. Window sill gasket
4. Bottom rail
4. See Figure 23. Secure case to window sill by
screwing two 7e" countersunk screws (Item B) into
sill through holes located in front support rail.
NOTE: Drill Va" pilot holes in window sill to make screws
easier to drive.
5. See Figure 24. Screw one Л' adjusting foot into
each outside support (Item D) as far as it will go.
(Adjustments can be made more easily after unit is
in place.) Do not attempt to straighten outside
supports or structural integrity of support may be
compromised.
1^" screw (Item E) for each support. Mount vertical
arms (tab with hole) as close as possible to sill.
When properly positioned, adjusting foot faces
house.
7. See Figure 25. Insert tabs on angled support arms
into nearest large holes along bottom of outer case,
one side at a time. Align hole in vertical support arm
tabs with small holes in bottom of case and drive
screws (Item E) into front tabs.
Rgure 25. Attaching Outside Supports to Outer Case
1. Outer case
2. Insert back support arm tab in large hole
3. Support bracket
4. Attach front support arm with screw through small
hole