Kenmore 70089 - Manual (Page 16)

Installation
A
CAUTION
To avoid damage to outside wall of house, especially
if wall is weak or outside supports sit between studs
in wall, place wood blocks (not provided) between
wall and each adjusting foot.
8. See Figure 26. Place carpenters’ level on outer
case. Rear of case should be 14“ to %" lower than
front of case (about bubble on level). Turn each
adjusting foot on outside supports in or out until It
begins to contact wall. Adjust position to achieve
proper slope for case.
9. See Figure 27. Position sash bracket (Item F) on top
of indoor sash, flush with outdoor sash. Secure
bracket to outside sash using Va" sash bracket
screw (Item G). Drill a Ve’ pilot hole so screw is
easier to install.
Figure 27. Installing Sash Bracket
1. Indoorsash
2. Sash bracket
3. Sash bracket screw
10. See Figure 28, Expand right side curtain on air
conditioner until curtain is tight against window
frame. With curtain tight against frame, find top hole
on curtain and mark location on indoor sash. Drill
Ve“ pilot hole into window sash, and secure curtain
to sash with Phillips screw (Item H). Repeat for left
side curtain.
11. See Figure 29. Measure and cut window seal strip
(Item)) to width of window. Stuff window seal strip
between outdoor glass and top of indoor sash for
tight seal to keep out heat and insects.