Installation procedure, Installation – Kenmore 70089 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Installation

2. See Figure 8. Thread adjusting foot (Item B) through

bottom of support bracket (Item C). Measure width
of window and mark center point of outside silt.

Installation Procedure
1. See Figure 7. Raise indoor sash and measure sash

width, including portion in window track. Cut window
sill gasket (Installation Kit Item A) to length of indoor
sash and apply to rear of indoor window sill. To
apply gasket, peel back about 2" of paper covering
gasket adhesive, and carefully press exposed
adhesive to one end of window sill. Slowly peel away
remaining paper cover from gasket adhesive, and
press gasket to sill as paper is pulled away.

If window has been modified for installed storm

window, apply gasket to wood strip added to sill.

For mobile home installation, apply gasket to

outdoor side of window frame txittom lip.

Figure 7. Applying Window Sill Gasket

1. Indoor sash

2. Indoor sill
3. Paper covering gasket adhesive

4. Gasket

3. See Figure 9. Center support bracket on outside sill,

from rear edge of indoor sill. Secure bracket to

outdoor sill with 2 hex-head screws (Item D).

Figure 9. Installing Support Bracket

1. 1^/ie"gap

2. Center of window
3. Hex-head screws

4. Bubble level

Advertising
This manual is related to the following products: