Installation, Procedure – Kenmore 580.75116 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION
procedure
b
Remove the backing from the support blocks
and attach them to the inside of the wall sleeve
as shown F!G 15. Slide the baffle into slots of
the support blocks.
Assemble trim as described in Step 6,
Procedure A.
A
CAUTION
• Air conditioners covered in this manua! pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to avoid
cuts from sharp metal fins on front and rear coils.
• Make sure air conditioner does not fall during
removal.
• If unit does not operate after installation check, to be
sure the circuit interrupter has not been tripped. Refer
to the Troubleshooting guide for reset procedure.