Kenmore 790.479 - Manual (Page 11)

Consumer Defined Control
Note: The Consumer Defined Control features are adjustments to the control that will not affect cooking results. These include the
Oven Lockout, Temperature Display and Silent Control Operation features.
Setting Oven Lockout Feature
The pad controlsthe Oven Lockoutfeature. The Oven Lockoutfeatureautomatically locks theoven doorand prevents theoven
from being turned on. It does not disable the clock, Kitchen Timer or the interior oven lights. The ovens can be locked individually.
INSTRUCTIONS
To activate the Oven Lockout feature
1
.
2
.
Press and hold
( stop )
for 3 seconds
"LOC" and Q will disappear from the display. "DOOR" and
"LOCKED" will flash in the display until the oven door has
completely unlocked.
2. The wall oven is again fully operational.
Note: Because you can set the oven lockout individually, the lower oven
can be used when the upper oven lockout feature is on.
PRESS
^^for
3 seconds
DISPLAY
After 3 seconds a beep will sound, "DOOR", "LOCKED" will flash
and "Loc", "UPPER" and Q will appear in the display (Figure 1).
Once the oven door is locked the "DOOR" and "LOCKED" indicator
will stop flashing and remain in the display. Allow 15 seconds for
the oven door to lock.
To reactivate normal oven operation:
1. Press and hold for 3 seconds. A beep will sound. "UPPER"
Figure 1
sT^ for
3 seconds
Setting Silent Control Operation
The DELAY START (^) and FLEX CLEAN (a^ pads control the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control
can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.
INSTRUCTIONS
To change control from normal sound operation to
silent control operation
1. Press and hold (^|) for 6 seconds. A beep will s o u n d , w i l l
appear, "UPPER" and "DELAY" will flash in thedisplay(Figure2).
After 6 seconds, a beep will sound and "SP" (Speaker) will appear
in the display (Figure 3).
Press to switch between normal sound operation and silent
operation mode.
If "SP" appears (Figure 3), the control will operate with normal
sounds and beeps. I f a p p e a r s (Figure 4), the control is in the
silent operation mode.
2
.
3. Press START to accept the change or press to reject the
change.
PRESS
for 7 seconds
Note: The control will always beep at the end of a kitchen timerand will
beep when a set temperature has been reached, even if the control is set
to silent operation.
DISPLAY
Figure 2
Figure 3
Figure 4
11