B. rotary valve service, Disassembly, Servicing the valve – Kenmore ULTRASOFT 175 625.388170 User Manual
Page 24: Assembly, Rotary valve service -5, Service tech. information
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
J.J J, J J. J.J J, J J. J.J J, J J. J.J
SECTION 5
SERVICE TECH. INFORMATION
B. ROTARY VALVE SERVICE
Before working on the valve, turn off the water sup
ply and disconnect from electrical power. TO RE
LIEVE PRESSURE:
• 3 VALVE BYPASS: Close the inlet valve and open
a soft water faucet. Then close the outlet valve and
open the bypass valve.
• SEARS SPECIAL BYPASS: Slide the bypass valve
stem to bypass position. Loosen 3 hex head screws
toward the back side of the valve to allow pressure
water to bleed out. Catch water with a rag.
DISASSEMBLY
To remove a part or group of parts, refer to the valve
drawing. A common screwdriver or nut driver,
Phillips screwdriver and pliers are the only tools
needed to completely disassemble.
SERVICING THE VALVE
Inspect all o-rings, seals and gaskets for wear or de
fects.
Inspect the bottom surface of the rotor for scratches,
chips or wear.
Note:
If replacement is needed, be sure to use the current
replacement part.
ASSEMBLY
Be sure all parts are in place and in the proper posi
tion. Lubricate ALL o-rings and seals with FDA ap
proved silicone grease. To install the rotor seal, first
place the seal into the valve groove, rounded side
down (see cross-section). Apply a light coating of
silicone grease to the seal's crossing ribs. Then, care
fully center the wear strip on the seal, and push it
downward onto the seal.
Install the nozzle and venturi seal and drain seal.
Assemble wave washer bearing, the wave washer,
and two o-rings onto the rotor top shaft. Then center
the rotor in the valve body, on the rotor seal.
Lower the cover onto the valve body and rotor shaft.
Then install the cover holding screws. Before tight
ening the screws, install the valve cam and gear.
Then, turn the rotor (clockwise only) to service posi
tion. Tighten the screws using a criss-cross pattern.
If a torque wrench is available, torque to 30-40 inch
pounds.
Lubricate the gear on the motor, and the valve cam
gear with Molykote grease, or other high quality
gear lubricant.
Be sure to orient switch as shown, with lever toward
the cam.
5 - 5
Problems,^ Questions? Call 1-800-426-9345 Kenmore Water Line