Removing and replacing lift-off oven door, To remove oven door, To replace oven door – Kenmore 790.7050 User Manual

Page 17: Special door care instructions, Lift-off, Care & cleaning, Removing and replacing, Oven door

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Removing and replacing

lift-off

oven door

Care & Cleaning

ik CAUTION

i To avoid possible injury when removing or

replacing the oven door, follow the instructions below

carefully and always hold the oven door with both hands

positioned away from the door hinge area.

ik CAUTION

I

The door is heavy. For safe, temporary

storage, lay the door flat with the inside of the door facing

down.

To remove oven door:

1.

Open oven door completely (horizontal with floor - See

Fig. 1).

2.

Remove

2

screws located on the inside of the oven door

liner (See A Fig. 2).

3.

Insert the 2 screws into the door hinge holes located on

the side of the hinge arm, one into each hinge (See B

Fig. 2).

4.

Close oven door until the door stops, (do not force the

door to close any further). The placement of these

screws should keep door open in about

a

45

degree

position.

5.

Grasp oven door firmly on both sides and slide door up

and off hinges at the same angle (See Fig. 3).

6

.

To clean oven door, follow the instructions provided

listed in the cleaning chart under “oven door”.

To replace oven door:

1. Be sure the hinge arms remain at the 45 degree angle

position. Be sure the screws are still locking the hinge

arms from moving. If the screws fall out of the hinge

holes, the hinge(s) may snap back against the oven

frame and could pinch fingers or chip the porcelain

finish on the oven front frame.

Hold door at the sides near the top while resting the

lower front of door on your knee. Insert the door

channels at the bottom of door over the door hinges,

(See Fig. 3).

Allow the door to slide down into the door hinges

evenly at the same 45 degree angle. The hinge arms

should be inserted into the bottom corners as far as

they can go.

Open door completely (horizontal with floor) and

remove both screws from holes in door hinges.

Reinstall the 2 screws into the door liner (See C Fig. 2).

If the door is not in alignment with the oven frame,

remove door and repeat the above steps.

2

.

3.

4.

5.

6

.

Fig. 3

Special door care instructions -

Most

oven doors

contain

glass that can break. Read the

following recommendations:

Do not close the oven door until all the oven racks are

fully in place.

Do not hit the oven door glass (if equipped) with pots,

pans, or any other object.

• Scratching, hitting, jarring or stressing the oven door

glass (if equipped) may weaken the door structure

causing an increased risk of breakage at

a later time.

17

Advertising
This manual is related to the following products: