Caution, Burn, Check – Kenmore 415.1615111 User Manual

Page 7: A gas

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

For Safe Use of Your Grill and to Avoid Serious

Injury:

• Do not let children operate or play near grill.

• Keep grill area clear and free from materials that

burn.

• Do not block holes in sides or back of grill.

• Check

burner flames regularly.

• Use grill only in well-ventilated space. NEVER use

in enclosed space such as carport, garage, porch,

covered patio, or under an overhead structure of

any kind.

• Do not use charcoal or ceramic briquets in

a gas

grill. (Unless briquets are supplied with your grill.)

• Use grill at least 3 ft. from any wall or surface.

Maintain 10 ft. clearance to objects that can catch

fire or sources of ignition such as pilot lights on

water heaters, live electrical appliances, etc.

Apartment Dwellers:

Check with management to learn the requirements

and fire codes for using an LP gas grill in your

apartment complex. If allowed, use outside on the

ground floor with

a

three (3) foot clearance from

walls or rails. Do not use on or under balconies.

NEVER attempt to light burner with lid closed. A

buildup of non-ignited gas inside a closed grill is

hazardous.

Never operate grill with LP cylinder out of

correct position specified in assembly

instructions.

Always close LP cylinder valve and remove

coupling nut before moving LP cylinder from

specified operation position.

Safety Tips

A Before opening LP cylinder valve, check the coupling nut

for tightness.

A

When grill is not in use, turn off all control knobs and LP

cylinder valve.

A

Never move grill while in operation or still hot.

A

Use long-handled barbecue utensils and oven mitts to

avoid burns and splatters.

A Maximum load for sideburner and side shelf is 10 lbs.

A

The grease tray must be inserted into grill and emptied

after each use. Do not remove grease tray until grill has
completely cooled.

A

Clean grill often, preferably after each cookout. If a

bristle brush is used to clean any of the grill cooking
surfaces, ensure no loose bristles remain on cooking
surfaces prior to grilling. It is not recommended to clean
cooking surfaces while grill is hot.

A

If you notice grease or other hot material dripping from

grill onto valve, hose or regulator, turn off gas supply at
once. Determine the cause, correct it, then clean and
inspect valve, hose and regulator before continuing.

Perform a leak test.

A

Keep ventilation openings in cylinder enclosure (grill

cart) free and clear of debris.

A

Do not store objects or materials inside the grill cart

enclosure that would block the flow of combustion air to the
underside of either the control panel or the firebox bowl.

A

The regulator may make a humming or whistling noise

during operation. This will not affect safety or use of grill.

A If you have a grill problem see the "Troubleshooting Section".

A

If the regulator frosts, turn off grill and LP cylinder valve

immediately. This indicates a problem with the cylinder and
it should not be used on any product. Return to supplier!

CAUTION

Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety reasons.

Do not use water on a grease fire. Personal injury
may result. If a grease fire develops, turn knobs and
LP cylinder off.

Do not leave grill unattended while preheating or
burning off food residue on HI. If grill has not been
regularly cleaned, a grease fire can occur that may

damage the product.

Ignitor Lighting the Grill

A Do not lean over grill while lighting.

1. Turn OFF gas burner control valves.

2. Turn ON gas at LP cylinder.

3. Open lid during lighting.

4. To ignite, push and turn the IGNITION BURNER knob to HI.

5. Push and hold ELECTRONIC IGNITION button until the

IGNITION BURNER lights.

6. If ignition does NOT occur in 5 seconds, turn the burner

controls OFF, wait 5 minutes for gas to clear away, and
repeat the lighting procedure.

7. To ignite remaining burners, turn each burner knob in

sequence to the HI position, starting with the burner
closest to the IGNITION BURNER.

8. Once each burner has ignited, turn knobs to desired

setting. If ignitor does not work, follow match lighting
instructions.

Lighting instructions are continued on the next page

464220311 • 7

Advertising