Amir:l, Caution – Kenmore 415.1615111 User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

A

A

Turn cor

in use.

itrols and gas source or tank OFF wf

sen

not

A

CAUTION

A

If ignitio
burnerc

lighting

the valv

burnerc
injury.

n does NOT occur in 5 seconds, turn

rontrols OFF, wait

5

minutes and

reps

procedure.

If

the burner does not igr

e open, gas will continue to flow out

ind could accidently ignite with risk

the

sat

the

life

with

of the

of

Match-Lighting

A

Do

not

lean over grill while lighting.

1. Open lid. Turn ON gas at LP cylinder.

2.

Place match into match holder (hanging from side panel

of

grill). Light match; then light burner by placing match

through the match light hole on right or left side of grill.

3. Push in and turn far right or far left burner knob to the HI

position, depending on match light hole selected. Be sure

burner lights and stays lit.

4. Light adjacent burners in sequence by pushing knobs in

and turning to the HI position.

Sideburner Ignitor Lighting

A Do not lean over grill while lighting.

1. Open sideburner lid. Turn ON gas at LP cylinder.

2. Turn sideburner knob to the HI position, push and hold

ELECTRONIC IGNITION button.

3. If sideburner does NOT light within

5

seconds, turn knob

to OFF, wait

5

minutes, then repeat lighting procedure.

Sideburner Match Lighting

1. Open sideburner lid. Turn ON gas

at LP cylinder.

2. Place lit match near burner.

3. Turn sideburner knob to the HI

position. Be sure burner lights and

stays lit.

Burner Flame Check

• Remove cooking grates and flame tamers. Light burners,

rotate knobs from HI to LOW. You should see a smaller

flame in LOW position than seen on HI. Perform burner

flame check on sideburner, also. Always check flame prior

to each use. If only low flame is seen refer to "Sudden

drop or low flame" in the Troubleshooting Section.

Amir:L

& & & & &

Turning Grill Off

• Turn all knobs to the OFF position. Turn LP cylinder OFF by

turning hand-wheel clockwise to a full stop.

Ignitor Check

• Turn gas off at LP cylinder. Press and hold electronic

ignitor button. "Click" should be heard and spark seen

each time between each collector box or burner and

electrode. See "Troubleshooting" if no click or spark.

Valve Check

• Important: Make sure gas is off at LP cylinder before

checking valves. Knobs lock in OFF position. To check

valves, first push in knobs and release, knobs should spring

back. If knobs do not spring back, replace valve assembly

before using grill. Turn knobs to LOW position then turn

back to OFF position. Valves should turn smoothly.

Hose Check

• Before each use, check to see if hoses are cut or worn.

Replace damaged hoses before using grill. Use only

identical replacement part valve/hose/regulator as

specified in the Parts List of this Use and Care Guide.

General Grill Cleaning

• Do not mistake brown or black accumulation of grease

and smoke for paint. Interiors of gas grills are not painted

at the factory (and should never be painted). Apply a

strong solution of detergent and water or use a grill

cleaner with scrub brush on insides of grill lid and bottom.

Rinse and allow to completely air dry. Do not apply a

caustic grill/oven cleaner to painted surfaces.

Plastic parts: Wash with warm soapy water and wipe dry.

A

Do not use citrisol, abrasive cleaners, degreasers or a

concentrated grill cleaner on plastic parts. Damage to

and failure of parts can result.

Porcelain surfaces: Because of glass-like composition,

most residue can be wiped away with baking soda/water

solution or specially formulated cleaner. Use nonabrasive

scouring powder for stubborn stains.

Painted surfaces: Wash with mild detergent or

nonabrasive cleaner and warm soapy water. Wipe dry

with a soft nonabrasive cloth.

• Stainless steel surfaces: To maintain your grill’s high

quality appearance, wash with mild detergent and warm

soapy water and wipe dry with

a

soft cloth after each

use. Baked-on grease deposits may require the use of an

abrasive plastic cleaning pad. Use only in direction of

brushed finish to avoid damage. Do not use abrasive pad

on areas with graphics.

• Cooking surfaces: If a bristle brush is used to clean any of

the grill cooking surfaces, ensure no loose bristles remain

on cooking surfaces prior to grilling. It is not

recommended to clean cooking surfaces while grill is hot.

8 • 464220311

Advertising