Before you call • solutions to common problems – Kenmore ELITE 790. 7830 User Manual

Page 39

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Before You Call • Solutions to common problems

Problem

Oven smokes excessively when broiling.

Solution

• Incorrect setting. Follow broiling instructions in Setting Oven Controls

section.

• Be sure oven door is closed when broiling.

• Meat too close to upper burner. Reposition the oven rack to provide proper

clearance between the meat & the upper burner. Preheat oven when

searing.

• Meat not properly prepared. Remove excess fat from meat. Cut remaining

fatty edges to prevent curling, but do not cut into lean.

• Grease has built up on oven surfaces. Regular cleaning is necessary when

broiling frequently. Old grease or food spatters cause excessive smoking.

Flames inside oven or smoking from oven

vent.

Excessive spillovers in oven. For example this will happen for pie

spillovers or large amounts of grease left on the oven bottom. Wipe up

excessive spillovers before starting oven. If flames or excessive smoke are

present see Broil in Setting Oven Controls section.

Convection fan does not rotate.

• Allow 6 minutes for convection fan to start rotating after setting Convection.

Oven door is open. Convection fan will turn off if oven door is opened when

Convection is active. Close oven door.

Flex Clean does not work.

Soil not completely removed after Flex

Clean.

• Oven control not set properly. Review instructions in Flex Clean section.

• Flex Clean was interrupted. Review instructions in Flex Clean section.

• Excessive spillovers on oven bottom. Remove before starting Flex Clean.

• Failure to clean soil from the oven frame, the door liner outside the oven

door gasket and the small area at the front center of the oven bottom.

These areas are not in the self-cleaning area, but get hot enough to burn

on residue. Clean these areas before the self-cleaning cycle is started.

Burned-on residue can be cleaned with a stiff nylon brush and water or a

nylon scrubber. Be careful not to damage the oven gasket.

Oven light does not work.

Be sure the oven light is secure in the socket. Also see Replacing oven light

in the Care & Cleaning section.

39

Advertising