Assembly instructions – Kenmore ELITE 141.1668 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Assembly Instructions

Figure 1

CAUTION:

While it is possible for one person to

assemble this grill, obtain assistance from another
person when handling some of the larger, heavier

pieces, especially the grill head.

1. Open Lid of shipping carton and remove top sheet of

cardboard. Lay cardboard sheet on floor and use as
a work surface to protect floor and grill parts from
scratches.

2. Slice all carton corners with a sharp utility knife to

lay open the carton panels. This will allow you to
raise the grill head Lid, remove the components
packed inside the head, and make the head easier
to lift.

3. Remove packing materials and parts boxes resting

on grill head

4. With an assistant, lift the grill head away from the

shipping carton and place it on the cardboard work
surface.

5. Open all parts boxes. Use the parts list to check

that all parts have been included.

6. Inspect the grill for damage as you assemble it. Do

not assemble or operate the grill if it appears
damaged. If there are damaged or missing parts
when you unpack the shipping box, or you have
questions during the assembly process, call:

1-888-317-7642

8

a.m. -

8

p.m CST, Mon. - Frt.

Assembling The Grill Cart

NOTE: To aid in assembly, compare hardware to
diagrams on page 6

1. Turn over the Bottom Shelf on floor. Install the

4 Casters to Caster Seats on the Bottom Shelf.
Align the holes on Caster with the threaded

holes on Caster Seat. Tighten securely by
using 16 of the 1/4"x1/2" Phillips head screws
provided. See Fig.

1

.

2. Before attaching the Bottom Shelf to Cart Side

Panels be sure Door Stop for Magnets on the

Bottom Shelf and holes for Door Axle Brackets

on Cart Side Panels are located on the front
side. See Fig. 2.

3. Install the Bottom Shelf between Cart Side

Panels. Align the holes on Cart Side Panels

with the threaded holes at the corners of

Bottom Shelf. Tighten securely by using 8 of
the 1/4”x50mm Phillips Head Screws provided.
See Fig. 2.

4. Install the Rear Panel to inside of rear Cart

Side Panels and to rear of Bottom Shelf. Align

the holes on the Rear Panel with the threaded

holes on rear Cart Side Panels and rear
Bottom Shelf. Tighten securely by using 7 of
the 1/4"x1/2" Phillips Head Screws provided.
See Fig. 3.

CASTER

Figure 2

AXLE BRACKET

Figure 3

Advertising