Cleaning the cooktop, burner heads, caps & grates, General, Care & cleaning – Kenmore ELITE 790.7943 User Manual

Page 34

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Cleaning the Cooktop, Burner Heads, Caps & Grates

The cooktop is designed to make cleaning easier. Because the gas Burners are sealed, cleanups are easy when spillovers
are cleaned up immediately.

The cooktop, Burner Heads and Caps should be routinely cleaned. Keeping the Burner Head Ports clean will prevent
improper ignition and an uneven flame. Refer to the following instructions:

General

Care & Cleaning

• Cleaning Cooktop, Burner Caps, Burner Heads & Grates

THE COOKTOP IS NOT REMOVABLE.

Do not attempt to remove or lift the cooktop.

iàCAUTION

Use caution when replacing the Burner Caps so the Electrodes are not damaged. This may cause a

delayed ignition or prevent the burner from igniting.

/-“N

Surface

(1st)

Burn-'

V_y Graie

^

— s. Surface

-^Burner

Surface

_____ nr/ASLirner

Head

To Remove and Replace the Surface Burner Caps and Burner Heads -

Remove in the following order: (1st) surface Burner Grates, (2nd) Burner Caps

and (3rd) Burner Heads. Reverse the procedure above to replace the surface

Burner Caps, Burner Heads and Burner Grates.

Do not remove any parts from the cooktop until they have completely

cooled and are safe to handle. Do not operate the surface Burners without
the Burner Caps and Burner Heads properly in place.

To Clean the surface Burner Caps and Burner Heads

- Use a soap-filled

scouring pad or a mild abrasive cleanser to clean the surface Burner Caps and

Burner Heads. The ports (or slots) around the Burner Heads must be routinely

cleaned. If residue still remains in these ports, use a small-gauge wire or needle
to clean the slots or holes. For proper flow of gas and ignition of the burner—

DO

NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER

MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. ALWAYS

keep the surface Burner Caps and Burner Heads in place whenever the gas

Burners are in use.

To Clean the Burner Grates (all models)

- The Burner Grates are dishwasher

safe and may be cleaned in the dishwasher. Remove any excessive soils before
placing in the dishwasher.

To Clean the Cooktop and contoured areas of the Cooktop

If a spill occurs on or in the recessed or contoured areas, blot up spill with an

absorbent cloth. Rinse with a clean, damp cloth and wipe dry. Do not use harsh
abrasive cleaners on the cooktop. They can scratch the pocelain. Completely
rinse any mild cleaners used from the surface or the porcelain cooktop may
become damaged during future heating.

DO NOT

use spray oven cleaners on

the cooktop.

34

Advertising