FRIGIDAIRE 819042236-01 - Manual (Page 3)

IN STALL. ATI ON
8. If you wish to keep the unit be operated at higher
performance state, remove the steel rear grille and
attach the plastic rear grille. The plastic grille will
minimize the recirculation of hot discharge air.
Plastic rear grille
Steel rear grille
Fig. F
11 .Install the new unit into the wall sleeve.
12.To assemble trim, snapthe tab ofeach piece into
the slot of the other piece as shown below. Remove
the backing from the trim foam and stick thatto the
inside of the trim as shown below.
Horizontal
Trim Foam Vertical
Trim Foam
Assemble Trim
Fig. I
9.If thedepth ofyour existing wall sleeve is less than
or equal to 20”, skip to step 11. Otherwise, cut the
baffles and the support blocksaccording to length “A”
in thetable below.
Depth “D” of the
existing wall
sleeve (inches)
Length “A”
(inches)
20<D^20^g
%
2 0 % < D ^ 2 ^ % 1-^/4
21^<Di24 4
12.Slide trim over thefront ofthe airconditioner until
trim isflush with sleeve as shown below.
_____________________ ^_____________ Fig. J
NOTE: Be sure to route the cord through the trim
frame before placing the trim frameon the unit.
10.Remove the backing from the support blocks and
attach them to the inside ofthe wall sleeve as shown
FIG H. Slide the baffle into slotsof thesupport blocks.
•Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to moveand install theunit. To prevent injury
or strain, use properlifting and carrying techniques
when moving unit.
• When handling the air conditioner, be careful tc
avoid cuts from sharp metal fins onfrontand rear
coils.
• Make sure air conditioner does not fall during
removal.