Materials and basic tools needed, Materials needed, Basic tools – Kenmore 153.31242 User Manual
Page 7: Additional tools needed when sweat soldering
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MATERIALS AND BASIC TOOLS NEEDED
Materials Needed
To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your type of installation.
WATER HEATER INSTALLATION KIT
WITH FLEXIBLE CONNECTORS FOR 3/4”
THREADED OR COPPER PLUMBING.
EXPANSION TANKS FOR THERMAL
EXPANSION CONDITIONS AVAILABLE IN
2 GALLONS , AND 5 GALLONS CAPACITY
THROUGH LOCAL SEARS STORE OR
SERVICE CENTER.
METAL DRAIN PANS AVAILABLE
IN 20” DIAMETER FOR WATER
HEATERS HAVING ADIAMETER18”
OR LESS AND IN 24” DIAMETER
FOR WATER HEATERS HAVING A
DIAMETER OF 22” OR LESS.
Basic Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
Sears store.
Pipe Wrench (2)
Screwdriver
6 Foot Tape or Foiding Ruie
Garden Hose
Driii
Pipe Dope or Teflon Tape
ROLL OF TEFLON TAPE (USE ON
WATER CONNECTIONS)
C:
PIPE DOPE (SQUEEZE TUBE)
USE FOR WATER CONNECTIONS
DRILL
SLOT-HEAD SCREWDRIVER
PHILLIPS SCREWDRIVER
GARDEN HOSE 6 FOOT TAPE
PIPE WRENCH
Additional Tools Needed When Sweat
Soldering
Tubing Cutters or Hacksaw
Propane Torch
Soft Solder
Solder Flux
Emery Cloth
Wire Brushes
TUBING CUTTER
O
g
HACKSAW
ROLL OF
EMERY CLOTH
ROLL OF
LEAD-FREE
SOFT SOLDER
a
SOLDER
FLUX
3/4” (19 mm) WIRE BRUSH
PROPANE
TORCH
1/2” (13 mm) WIRE BRUSH