Kenmore 3241 - Manual (Page 13)

General Care & Cleaning
Sealed Burner iVlodeis
(some models)
To Clean the Burner Grates, Contoured Burner Pans, Burner Cap and Burner Base
The burner grates, contoured burner pans, burner caps and burner base should be routinely cleaned. Keeping the
burner ports clean will prevent improper ignition and an uneven flame. See instructions below.
To Clean the Burner Grates
Be sure burners and grates are cool before you place your hand, a pot holder,
cleaning cloths or other material on them. The cast iron burner grates can be washed in
hot soapy water. Rinse thoroughly and dry the grates with a cloth; don't put them on the
cooktop while still wet. Be sure the grates are positioned securely over the burners.
To remove burned on food, place the grates in a covered container or plastic bag.
Add 1/4 cup ammonia and soak for 30 minutes. Wash, rinse well and dry. An abrasive
cleaner can be used for stubborn stains.
Burner grate can appear in
different shapes.
To Clean the Contoured Burner Pans
The burner pans are removable from the cooktop. The burner pan forms a recessed well area located around each
burner unit. If spill occurs on it, after the burners are turned off, rinse with water and wipe dry.
Bi-iri'ier '
Base I
sPai
Gas
' Opening
Elecirode'
To Clean the Burner Cap
Remove burner cap. Use soap-filled pad or mild abrasive cleanser to clean i “)
burner caps. If necessary, cover stubborn spots with an ammonia-soaked *
paper towel for 30 minutes. Rub gently with a mixture of clean water and f T
vinegar. Wipe dry. Remove all cleaners or the porcelain may become damaged '
during future heating.
To Clean the Removable Burner Base and Gas Opening
(some models)
The ports (or slots) around the burner base must be routinely cleaned. Use a
small-gauge wire or needle to clean small slots or holes.
Note: If the electrode is damaged or broken, the surface burner will not light
because it will not spark. Manual lighting with a match is still possible.
For proper flow of gas and ignition of the burner - DO NOT ALLOW SPILLS,
FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE
GAS OPENING TUBE. Gas must flow freely through the small hole in the
brass orifice for the burners to light properly. If the gas opening orifice becomes
soiled or clogged, use a small-gauge or needle to clean. ALWAYS keep the
burner cap in place whenever a surface burner is in use.
To Replace the Burner Base and the Burner Cap
Make sure the pieces are thoroughly dry before placing back.
1. Replace burner base and burner cap in their places. Make sure each burner
cap and burner base are properly aligned and leveled.
2. Replace the burner grate.
3. Turn the burner on to determine if it lights. If the burner does not light after
cleaning, contact a Sears or other qualified service dealer. Do not service
the sealed burner yourself.
13