Setting surface controls, To operate the surface burner, Manual ignition – Kenmore 3241 User Manual

Page 9: Sealed burner iviodeis

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Setting Surface Controls

Sealed Burner iViodeis

Your appliance may be equipped with any combination of the following burners:
Simmer Burner: This burner is best used for simmering delicate sauces, etc.
Standard Burner: This burner can be used for most all surface cooking needs.

Power Burner: This larger burner is best used when bringing large quantities of
liquid to temperature and when preparing larger quantities of food.
Regardless of size, always select a utensil that is suitable for the amount and

type of food being prepared. Select a burner and flame size appropriate to the

pan. Never allow flames to extend beyond the outer edge of the pan.

Each burner lights from an electric ignitor when its control knob is turned to the
lite position.

To operate the surface burner:

1. Place cooking utensil on burner.

2.

Push in and turn

the Surface Control knob to LITE.

Note:

All electronic

ignitors will click at the same time. However, only the burner you are turning on

will ignite.

3. Visually check that the burner has lit.
4. After the burner lights, turn the control knob to the desired flame size. The

control knobs do not have to be set at a particular mark. Use the guides and
adjust the flame as needed.

DO NOT

cook with the control knob in the LITE

position. (The electronic ignitor will continue to click if left in the LITE position.)

5. To turn the burner off, turn the control knob as far as it will go, to the OFF

position.

Manual Ignition

In the event of an electrical power outage, the surface burners can be lit manually.

To light a surface burner, hold a lit match to the burner head, then slowly turn the
surface control knob to LITE. Use caution when lighting surface burners manually.

Surface burner in use when an electrical power failure occurs will continue to
operate normally.

The surface control knobs
shown below may not look

identical to the Surface Controls
Knobs on your range; They are

only representational.

ik CAUTION

Do not operate the burner for an extended period of time

without cookware on the grate.

The finish on the grate may chip without

cookware to absorb the heat.

À CAUTION

I

Do not place plastic items such as salt and pepper shakers,

spoon holders or plastic wrappings on top of the cooktop when it is in use.

These items could melt or ignite. Pot holders, towels or wood spoons could catch
fire if placed too close to a flame.

Advertising
This manual is related to the following products: