Press – Kenmore Sens-A-Clean 665.95829 User Manual

Page 20

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

*

READJUSTING THE OVEN TEMPERATURE CONTROL
(OPTIONAL)

Although your new oven is properly adjusted to

provide accurate temperatures, it may cook
faster or slower than your old oven.

If you are not satisfied with the baking/roasting

results, you can change the temperature calibration

by following the steps below.

1. Press and hold BAKE for 5 seconds.

The display will show the current temperature
calibration, for example “0,” if you have not
already adjusted the temperature.

NOTE: DO NOT measure the oven temperature with

a thermometer. Opening the oven door will lower
the oven temperature and give you an incorrect

reading. Also, the thermometer temperature reading

will change as your oven cycles.

PRESS

BAKE

YOU SEE

2.

Set the new offset temperature.

Press TEMP (▲) or

(T)

pad(s) to raise or lower

the temperature in 10°F amounts. You can set

the temperature change to as low as -30°F or as
high as +30°F. A minus {-) sign will appear before
the number when decreasing the temperature
setting. The minus sign shows the oven will be
cooler by the displayed amount. There is no sign

in front of the number when increasing the

temperature setting.

3.

Enter the adjustment.

NOTE: You must press START/ENTER after
adjusting the calibration or your changes will not
be made.

PRESS

TEMP

A

(example when making oven

10“F warmer)

PRESS

STMT

ENTER

YOU SEE

C j n

J ' J U

(time of day)

The chart at the right tells you how much to adjust
the temperature calibration to get the cooking

results you want. You can figure out cooking results
by the amount of browning, moistness, and rising

times for baked foods.

ADJUST BY
THIS NUMBER
OF DEGREES

TO COOK FOOD...

(FAHRENHEIT)

A little more

+10

Moderately more

+20

Much more

+30

A little less

-10

Moderately less

-20

Much less

-30

Press and hold BROIL for 5 seconds. You will hear a

short tone and the temperatures displayed will

BROIL switch to ®C. To switch back to °F, repeat the

instructions above. Whenever you switch, “°C”

or “°F” will be displayed until another key is pressed.

20

Advertising
This manual is related to the following products: