Replacing the light bulb, For your safety, To remove – Kenmore 385.166551 User Manual
Page 106: To insert, Cleaning the feed dogs, Replacing the light bulb for your safety
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Replacing the light bulb
(T) Set screw
(2) Face plate
Turn off the power switch and unplug the machine.
Loosen the face plate set screw (T), and remove the face
plate (2).
For your safety:
• The machine is designed to use a 15 W Light Bulb,
Maximum. DO NOT use light bulb that exceeds 15 W.
• The light bulb will be HOT. Wait until it cools down.
To remove;
Push and twist to the left.
To insert:
Push and twist to the right.
Attach the face plate, and tighten the face plate set
screw.
CD To remove
0
To attach
0 Light bulb
Cleaning the feed dogs
0 Needle plate setscrew
0 Needle plate
Turn off the power switch and unplug the machine.
Open the looper and side covers.
Remove the needles and presser foot.
Remove the needle plate setscrew and needle plate.
0 Feed dogs
Push the lint around the feed dogs to the front with the lint
brush.
Replace needle plate, presser foot and needles.
Close the looper and side covers.
98