Dishwasher dispenser & detergents (continued), Rinse aid, Factors affecting performance – FRIGIDAIRE 154428101 User Manual

Page 7: Water pressure, Water ternperature, Dishwasher dispenser & detergents

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Dishwasher
Dispenser &
Detergents

(continued)

Rinse Aid

Rinse aid greatly improves drying and reduces

water spots and filming. Water “sheets ” off
dishes rather than forming water droplets that
cling and leave spots.

Rinse aids come in solid or liquid form. If your

dishwasher does not have a rinse aid dispenser, a
solid rinse aid should be fastened to the front
corner of the upper rack. When material dissolves
and the container is empty, it is time to replace it.

A dispenser for liquid rinse aid is located next to
the detergent cup and automatically releases a

measured amount of rinse aid during the last
rinse. If spotting and poor drying are problems,
increase the amount of rinse aid dispensed by
rotating the dial to a higher number. The dial is
located under the dispenser cap. The indicator will
be dark when full and will show clear when it is

time to refill.

To add liquid rinse aid, turn dispenser cap 1/4 turn
counterclockwise and lift out. Pour in rinse aid until

liquid touches the indicated fill level. Replace cap.

Do not overfill since this can cause oversudsing.

Wipe up any spills with a damp cloth.

The dispenser holds enough for 35 to 140 washes,
depending on the setting.

Factors Affecting
Performance

Water Pressure

The hot water line to the dishwasher must provide
water pressure between 20 and 120 psi.

Low water pressure may occur when laundry or

showers are in operation. Wait until water use is

reduced before starting dishwasher.

Water Ternperature

Hot water is needed for best dishwashing and

drying results. Water entering dishwasher should

be at least 120°F (49°C) to give satisfactory
results.

To check water temperature entering dishwasher:

Turn on hot water faucet nearest dishwasher
for several minutes to clear cool water from

pipes.

Hold a candy or meat thermometer in stream

of water to check the temperature.

If temperature is below 120°F (49°C), have a

qualified person raise the hot water heater
thermostat setting.

Important: Before starting a cycle, run hot

water to clear cool water from pipe.

Dispenser Opening

Indicator

Advertising