Kenmore 141.178600 - Manual (Page 12)

Installing Side Burner and Side Shelf Figure 9
1. Remove and discard the protective rubber boots
from the Side Shelf and Side Burner braces.
2, Enlisting the aid of an assistant, attach Side Burner
to the wheel side of grill. Align the 4 holes on the
Side Burner Frame with those holes on the Cart
Legs. Tighten securely using 4 of the 1/4"x3/4"
Phillips head screws provided. Remove the fastening
strip frome burner befor use. Attach the Side Shelf
to the opposite side of side burner. Insert Heat
Shield of Cooler between Cart Legs and Side Shelf
Frame, Tighten securely using 4 of the 1/4"x3/4"
Phillips head screws provide. See
Fig. 9.
3, The Brass Adaptor of the Gas Valve Assembly
(located directly behind the Side Burner control
knob) has 2 threaded fittings. Connect the Connec­
tion Tube from Grill Head to the horizontal fitting.
Connect hose end of LP gas regulator to vertical
fitting. Tighten both connections securely with ad­
justable wrench. See Fig. 9a.
4 , For Natural Gas grills: Connect the hose
end of the 12' Natural Gas Hose to the
vertical fitting as shown in
Fig. 9b. Also read
the natural gas safety instructions on the next
page.
5, On both LP gas and natural gas grills, con­
nect the Ignition Wire terminal from Side
Burner with the other from Grill Head. See
Fig. 9. Bind the connected Ignition Wires and
Connection Tube together using the supplied
Fastening Band.
6. Install and slide the 5 Tool Hooks onto the
Tool Holder from the narrow section. For
safety's sake, the Tool Hooks face in the
same direction as both ends of Toot Holder.
See
Fig. 9c,
7. Attach the Tool Holder to the left Side Shelf.
Align the holes on Tool Holder with the holes
on the left side of Side Shelf. Secure firmly
using 2 of the M6 Phillips head screws and
M6 nuts
packed with the Tool Holder,
8. Slide the 2 screw covers onto both ends of
Tool Holder. See Fig. 9c,
Figure 9a (LP gas model only)
GAS VALVE FOR
SIDE BURNER
Figure 9b (Natural gas model only)
GAS VALVE FOR
12