Installation clearances – Kenmore HE2 PLUS User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Selecting the proper location for your washer improves
performance and minimizes noise and possible washer “walk.”

Your washer can be installed under a custom counter, or in a

basement, laundry room, closet, or recessed area. See “Drain
System.”

Companion appliance location requirements should also be
considered. Proper installation is your responsibility.

You will need

■ A water heater set to deliver 120°F (49°C) water to the

washer.

■ A grounded electrical outlet located within 6 ft (1.8 m) of

where the power cord is attached to the back of the washer.
See “Electrical Requirements.”

Hot and cold water faucets located within 4 ft {1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi {137.9-689.6 kPa).

■ A level floor with a maximum slope of 1" (2.5 cm) under entire

washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.

■ A sturdy and solid floor to support the washer with a total

weight (water and load) of 400 lbs (180 kg).

Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.

Installation clearances

■ The location must be large enough to allow the washer door

to be fully opened.

■ Additional spacing should be considered for ease of

installation and servicing. The door opens more than 90“, and
it is not reversible.

■ Additional clearances might be required for wall, door, and

floor moldings.

■ Additional spacing of 1" (2.5 cm) on all sides of the washer is

recommended to reduce noise transfer.

■ Companion applianoe spacing should also be considered.

Washer Dimensions

Recommended installation spacing for custom
undercounter installation

The dimensions shown are for the recommended spacing.

Custom undercounter installation - Washer only

Recommended installation spacing for recessed or

closet installation, with or without a pedestal

The dimensions shown are for the recommended spacing.

Recessed area or closet installation

A

B

A. Side view - cioset or confined area

B. Closet door with vents

*Min. top and bottom air openings for closet door.

Recessed or closet installation - Washer on pedestai

(2.5 cm)

(68.6 cm)

A

(2.6 cm)

(2.5 cm) (77.6 cm) (10.2 cm)

A. Recessed area
B. Side view - closet or confined area

Advertising
This manual is related to the following products: