Basic tools, Additional tools needed when sweat soldering, Materials needed – Kenmore THE ECONOMIZER 153.33205 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Materials Needed

To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials,
depending on your type of installation.

EXPANSION TANKS FOR
THERMAL EXPANSION
CONDITIONS AVAILABLE
IN 2 GALLONS
(7.6 LITERS) AND
5 GALLONS (18.9 LITERS)
CAPACITY THROUGH
LOCAL SEARS STORE OR
SERVICE CENTER.

WATER HEATER INSTALLATION KIT WITH

FLEXIBLE CONNECTORS FOR 3/4”
(19.05 mm) OR
1/2” (12.7 mm) THREADED OR
COPPER PLUMBING AND FLEXIBLE GAS
CONNECTOR WITH FITTINGS.

DRAIN PANS AVAILABLE IN 20”
(508 mm) DIAMETER FOR

WATER HEATERS HAVING A

DIAMETER 18” (457 mm) OR
LESS, 24” (610mm) DIAMETER
FOR WATER HEATERS HAVING
A DIAMETER 22” (559 mm) OR
LESS AND AVAILABLE IN 28”
(711 mm) DIAMETER FOR

WATER HEATERS HAVING A

DIAMETER 26” (660 mm) OR
LESS.

Basic Tools

You may or may not need all these tools, depending on your
type of installation. These tools can be purchased at your local
Sears Store.

Pipe Wrenches (2) 14” (356 mm)
Screwdriver

Tin Snips
6’ (1.82 m) Tape or Folding Ruler
Garden Hose

Drill
Pipe Dope
or Teflon Tape

DRILL

ci=

SLOT-HEAD SCREWDRIVER

е^э=—

PHILLIPS SCREWDRIVER

TIN SNIPS

c

ROLL OF TEFLON

TAPE (USE ONLY ON

WATER CONNECTIONS)

GARDEN HOSE

6 FOOT TAPE

PIPE DOPE

(SQUEEZE TUBE)

USE FOR WATER AND GAS

CONNECTIONS

PIPE WRENCH

Additional

Tools

Needed

When Sweat Soldering

• Tubing Cutters or Hacksaw
• Propane Tank
• Soft Solder
• Solder Flux
• Emery Cloth
• Wire Brushes

A

TUBiNG CUTTER

PROPANE

TORCH

HACKSAW

ROLL OF

EMERY CLOTH

3/4” (19 mm) WIRE BRUSH

1/2” (13 mm) WIRE BRUSH

ROLL OF LEAD-FREE

SOFT SOLDER

SOLDER

FLUX

Advertising
This manual is related to the following products: