Kenmore 20938 - Manual (Page 3)

^djmi St
Ice cream is a good indicator for adjusting freezer temperatures Ice cream should be firm. If it is too soft, turn the cold
control to a higher number If ice cream is too hard and brick like turn the cold control to a lower number. After a few
days you may want to "fine tune" the cold control for the best temperature
Jealum
Stmt St
See pages 4 & 5 for features on your model
COLD CONTROL LOCATION
Cold control is located inside the freezer on the right
side
’
Cold control is set at #1. Allow freezer to run
about 4 hours to cool thoroughly before adding
food,
NOTE: Do not freeze more than 3 pounds of un­
frozen food per cubic feet of space Add more after
first load is frozen
'ypiAim Sujnd JLujk
WARNS OF ANY UNKNOWN POWER FAILURE
If light is out, quickly check:
® Power failure.
® Disconnected power cord
® Signal light burned out
NOTE: POWER SIGNAL LIGHT SHOWS
POWER TO FREEZER ONLY.
IF IT BURNS OUT
• Unplug power cord at wall,
® Remove base trim by pulling straight out
® Reach behind light and push entire light and
rubber plug forward
® Grasp light unit firmly and pull from rubber plug
® Replace new light unit securely into rubber plug
and snap into position. Replacement signal light
can be purchased at your nearest Sears Service
Center Plug in freezer
'Sedmd Sted
Helps hide smudges and fingerprints
T^oon, 6km
Located in your bottom hinge.
Never needs cleaning or adjusting.
In case of light failure.
Turn cold control off
Unplug power cord at wall
Replace bulb with 25W appliance bulb, wdiich
can be purchased through a Sears Service
Center
Plug in freezer and turn on
Jlock
Key pops out for security - store in safe place to
lock or unlock the freezer you must push the key
in the lock while turning The lock is spring
loaded so the key cannot be left in the lock,
'KmovaiU met XJwtt
z
C/3
r'
r
m
<
til
Q
O
d z
o
3
>
d
► tj
rrj
d
lid
tr!
c/r