Pioneer PD-M550 - Manual (Page 15)

TO PLAY ONLY DESIRED TRACKS/DfSCS
Programming a pause
inserting a pause in your program can be very useful when carrying
out recording. Press li instead of entering a track number, "PA"
appears on the display panel.
•
For example, when recording on both sides of a cassette tape,
if you program a pause after the last track to be recorded on
the first side, program playback will pause at that point to allow
you to switch tape sides. To resume program playback after the
player enters pause mode, press
II.
Notes:
m A pause can be programmed only when the program procedure
is performed under stop mode.
• A pause cannot be programmed at the beginning of a program
IP-01), and two pauses cannot be programmed one after the
other.
m A pause inserted in a program is counted as one step.
0 If a pause is programmed as the last step of a program, the
player will nor enter the pause mode.
To clear all of the program contents
(D
/ 1 ^
__ _
STOP
___^ ■
n
1____ 1
u /:?
EJECT
® During stop mode, press ■.
(D When the magazine is ejected, the program contents will be
cleared.
During program mode, press CLEAR on the remote control unit.
The last program step is erased and the contents of the previous
program step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However, tracks preceding the currently playing track cannot be
erased in this way.
To check
PD-M455/
the program contents (PD-M550/
PD-M4B3 only)
P - u i
© ©
n I
U f
©©
■ 3 - O P p - m
© © © ©
*
I
I
n
CHBCK
1 ' ^ 1
u I —L - i
/ 5^
----------- ij ■ uu ‘
@ © © ©
During progranp mode, set the player to stop mode and press
CHECK. The program contents will be displayed in the programmed
order.
i ^
• After confiifming the last program step, the display will show
"
0
-
00
" :
To modify the program contents (PD-M550/PD-
M455/PD-iyi453 only)__________________________
PD-M550
•L7 4 P
i ©
- u p
© ©
5 7
n
CZD
-► □
u
DISC TRACK
NUMBER NUMBER
During program mode, set the player to stop mode and press
CHECK so tlfiat the program step to be corrected appears on
the display, I
To correct tNe disc No., enter the new disc No. with the DISC
NUMBER buttons. For PD-M550, enter the new track No. with
the TRACK iflUMBER/Digit buttons. For PD-M455/PD-M453,
press N«^^1 so that the the new disc No. appears on the
display. For example, the programmed track No. 4 on the disc
No. 3 is changed to track No. 7 on the disc No, 5. using the
DISC NUMBER 5 button and TRACK NUMBER 7 button IPD-
M550), orKWl^W and PROGRAM (PD-M45S/PD-M453).
Repeat steps
1 and 2 to change other tracks as desired.
For PD-M55d, the HW or button can also be used to correct
the track No After selecting the track No., be sure to press
PGM, '
15
<PR81142>
En