Pioneer DE-SH9101 - Manual (Page 4)

CAUTION; USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
CAUTION: THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARDS»
[ FOR EUROPEAN AND U.K. MODELS ]
CAUTION
This product contains a laser diode of a higher class than
1, To ensure continued safety, do not remove any covers
or attempt to gain access to the inside of this product
Refer all servicing to qualified personnel,
The following caution label appears on your drive.
Location: bottom of the drive
I
i Ji 1
©Can use both rewritable and WORM media of large capacity
1 7GB (using DEC-17GMO/DC-17GWO) and delivers high­
speed data transfer,
@ Interchangeable with former PIONEER models
{DEC-702/DC-502A)
® 1 Mbyte data buffer is implemented
® Powerful error correction capability for bit error rate of less than 10
(when a PIONEER optica! disk is used)
® Long-life loading mechanism and dustproof construction for high
reliability
® Changer interface and Spindle control interface are implemented
© Low power consumption
® SCSI-2 command set is supported
PREPARATION
SETTING UP
Set the product on a level surface as shown In the figure This product
can be positioned vertically or horizontally, but in either case, be sure
that it is oriented in the proper direction (see right figure) Please note
that if the product is subjected to vibration, It might not yield adequate
performance.
CONFIRMATION OF ACCESSORIES
The following accessories are supplied with this product.
® Power cord............................
® Plug converter................
® SCSI connector cover,
® Operating instructions
® Manual eject screwdriver
NOTES:
The SCSI connector covers are attached to each of the SCSI
connectors on the rear panel at the shipment
When both or one of the SCSI connector is vacant, it should be
covered with SCSI connector cover to protect from electrostatic
discharge
HORIZONTAL SETTING VERTICAL SETTING
11
<ORM1057>
En