Howto set the factory presettings, The password is – Pioneer PDP-503HDE User Manual
Page 66
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOWTO SET THE FACTORY PRESETTINGS
Press and hold down CLEAR on the Media Receiver while it is in standby mode. Then press STANDBY/ON
on the Plasma Display or
0 - 9
on the remote control unit to turn the Plasma Display System on.
All setting items (except TV channel) return to the factory presetting.
I NOTE >
• Running the factory presetting operation also clears the password.
You can run the Auto Installation again by using the following steps.
1
Turn on the power of the Plasma Display and the Media Receiver.
2
Press MENU. (Make sure the menu screen displays.)
3
Press
T
to select “Setup”.
4
Press ENTER.
I
NOTE >
• If the passwor(d setting screen (displays, you need to enter your password.
• If you forget your password, refer to HOW TO SET THE EACTORY PRESETTINGS above.
5
Press A/V to select “Auto Installation”.
6 Press ENTER.
“Auto Installation completed” displays. After that, the screen changes to the TV mode.
The password is
I NOTE >
• As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar
place.
*1 SRS and the C#T symbol are trademarks of SRS Labs, Inc.
SRS technology is incorporated under license from SRS Labs, inc.
FOCUS and the C#T symbol are trademarks of SRS Labs, Inc.
FOCUS technology is incorporated under license from SRS Labs, Inc.
NOTE >
• Products above are a trademark or registered trademark of corporation.
(ID-63