Figure 12 a, Installing battery, Figure 15 – Kenmore 122.16641900 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

5. Using (3) 5/32 x 1/2" screws and (3) 1/2" lock

washers, securely attach side burner shelf to grill head.

Fully tighten two screws from previous step. Secure

side burner control panel to main control panel with
screw removed in step 2. (Fig. 11)

6. Repeat steps 2 through 5 to install side shelf.

Installing Side Burner Valve

1. Remove the two screws attaching side burner to

underside of side burner shelf to make room to install

side burner valve. See Figure 12 A inset.

2. Remove two screws and washers from side burner

control valve face. Insert side burner valve control
stem through hole in side burner control panel. See

Figure 12 B.

3. Place side burner control knob bezel over side

burner valve control stem. Secure bezel to control and

valve with 2 screws removed in step 2. Push control

knob onto valve control stem. See Figure 13.

4. Insert valve orifice tip into burner tube as shown in

Fig. 12. Reattach burner to underside of side burner

shelf with screws removed in step 1.
5. Plug ignition wire into igniter wire electrode on

underside of burner(Fig.14).

Figure 12

A

Figure 13

When you have finished assembling grill, make

I I

sure that all screws and nuts are tight and secure.

- .

Installing Battery

1 .Unscrew the ignition battery cap. (Found at far left of

control panel).

2.Install battery into ignition box with positive terminal

facing outward.

3.Replace the ignition battery cap after the battery has

been installed. (Fig. 15)

Figure 14

3pcs: V4 X V

2

Figure 11

Ipc: y4XV2”

Figure 15

Ipc: 5/32 X V

2

4 ,

0;

M]

\

10

Advertising