Kenmore TRUE HEPA 106.832 - Manual (Page 5)

LOCATION REQUIREMENTS
Do not blook air openings or
place air cleaner on soft surface
such as bed or sofa. This could
cause air cleaner to tip over,
blocking air intake opening.
Place air cleaner on a flat, level
surface at least 6 in. (15.2 cm)
away from heat sources such as
ranges or heaters.
This product is intended for
indoor use only.
6" (15.2 cm) Min.
Clearance
OPERATING AIR CLEANER
NOTE: Before operating air cleaner, record date of installation on HEPA filter so
you can replace it annually. To remove and replace HEPA filter, see the “Filter
Replacement” section.
Using the Controls
Power On/Off
1. Plug into a grounded 3 prong outlet.
2. Press POWER ON/OFF to start the
air cleaner.
3. Press FAN SPEED to select desired
speed.
4. Press POWER ON/OFF to stop the
air cleaner.
Sleep
Press SLEEP/LOCK to set the fan
speed to Low for 8 hours. The air
cleaner will then return to the previously
selected setting.
Control Lock
Locks the controls to prevent accidental
changing of the settings.
1. Press and hold SLEEP/LOCK for
5 seconds to set the Control Lock.
2. Press SLEEP/LOCK for 5 seconds to
unlock the controls.
Filter Status Lights
The Pre-Filter and HEPA Filter status
lights will help you know when to
change your filters. The green status
lights will move from New to Change at
pre-set intervals. When the red Change
status light is flashing, replace the filter
as indicated. See the “Filter
Replacement” section.