Kenmore 385.15516 User Manual
Page 70
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION VII. BUTTONHOLE
r n 1
Automatic Buttonhole
(T) Stitch selector:
Q(BH)
n
PATTERN
D
(2) Stitch length:
Blue zone
u
(3) Needle thread tension:
2 to 6
(4) Presser foot:
Automatic buttonhoie foot
(l)
LENGTH :=!
Preparation for sewing
(T) Groove
(2) Pin
Attach the automatic buttonhoie foot. Make sure the
groove on the holder catches the pin on the foot when
lowering the presser foot.
To sew
(1) Button holder
(D Buttonhole lever
The buttonhole size is automatically set by placing the
button in the rear of the automatic buttonhole foot.
The button holder on the foot takes a button up to 1.0”
(2.5 cm) in diameter.
Make a test buttonhole on an extra piece of the fabric to
check your settings.
Use interfacing on stretch fabrics.
Pull the button holder (T) to the back, and place the button
in it. Push it together tightly on the button.
Pull the buttonhole lever (2)down as far as it will go.
62