Materials and basic tools needed, Materials needed, Basic tools – Kenmore POWER MISER 153.336951 User Manual
Page 7: Basic too is
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Materials and Basic Tools Needed
Materials Needed
To simplify the installation Sears has available the installation
parts shown below. You may or may not need all of these materi
als, depending on your type of installation.
Gas
W ater Heater
Installation
lot
(1
ii
it
••
e
si
■aar
VENT ELBOW
WATER HEATER STAND 24"x24"xl8"
FOR USE WITH WATER HEATERS
INSTALLED IN RESIDENTIAL
GARAGES HAVING A DIAMETER 24"
OR LESS AND A RATED CAPACITY 75
GALLONS OR LESS
EXPANSION TANKS
FOR THERMAL
EXPANSION CONDI
TIONS AVAILABLE IN
1 GALLON AND 5
GALLON CAPACITY
THROUGH LOCAL
SEARS STORE OR
SERVICE CENTERS
FLEXIBLE WATER
HEATER GAS CON
NECTOR WITH
FITTINGS
WATER HEATER INSTAL
LATION KIT WITH FLEXI
BLE CONNECTORS FOR
3/4" OR 1/2" THREADED
OR COPPER PLUMBING
c
VENT PIPE
WATER HEATER HEAT
TRAPS HELP REDUCE HEAT
LOSS DUE TO THERMAL
SYPHONING
DRAIN PANS
AVAILABLE IN 20" DIAMETER FOR
WATER HEATERS HAVING A DIAME
TER IS" OR LESS AND AVAILABLE IN
28" DIAMETER FOR WATER HEATERS
HAVING A DIAMETER 26" OR LESS
Basic Tools
You may or may not need all of these tools, depending on your
type of installation. These tools can be purchased at your local
^ars store.
• Pipe Wrenches (2) 14"
• Screwdriver
• Tin Snips
• 6 Foot Tape of Folding Rule
• Garden Hose
• Drill
• Pipe dope or Teflon Tape
GARDEN HOSE
6 FOOT TAPE
SLOT-HEAD SCREWDRIVER
PIPE
WRENCH
PHILLIPS SCREWDRIVER
TIN SNIPS
ROLL OF TEFLON TAPE
(USE ONLY ON WATER
\l_
CONNECTIONS)
DRILL~
PIPE DOPE (SQUEEZE TUBE)
(USE FOR WATER AND
GAS CONNECTIONS)
ADDITIONAL
TOOLS
NEEDED
WHEN SWEAT SOLDERING
• Tubing Cutters or Hacksaw
• Propane Torch
• Soft Solder
■ Solder Flux
• Emery Cloth
• Wire Brushes
HACKSAW
\
lAs
3/4" WIRE BRUSH
1/2" WIRE BRUSH
ROLL OF LEAD FREE
SOFT SOLDER
PROPANE
TORCH
o
ROLL OP EMERY
CLOTH
SOLDER FLUX
TUBING
CUTTER