Pioneer BR-95 - Manual

The PIONEER BR-95 TV-CATV remote
control unit controls the Pioneer
converter as well as the "ON/OFF",
"MUTE" and "VOLUME" functions
of televisions that presently have
remote control.
If your television does not have remote
control, the "MUTE" and "VOLUME"
can be controlled by the CATV
converter if the converter is so equipped.
A. CATV CODE PROGRAM PROCEDURE
Al. To Program Remote for use with
a TV equipped with remote
control:
1.1 Enter "SET Mode" (See Note 1)
Note 1;
To enter the "SET Mode"
perform the following
procedumi^ —na
Depress gjyU & tUd Keys
simultaneously until indicator
lamp lights (approximately 3
seconds). If the indicator lamp
lights immediately^Hgi
«¡9
after pressing the {QQ &|[||j||
Keys, release the keys and try
again to depress the keys
simultaneously. Release keys
after lamp lights.
1.2 Press Key momentarily
1.3 Press keys "0", "0", "2", "5"
(Indicator lamp should blink twice and
turn off. If indicator lamp just turns
off, the code has not been entered
correctly and the procedure should be
repeated beginning at Step A1.1.1.
1.4 Program TV Code as defined in the
"TV Code Program Procedure"
A2. To Program CATV code for use
with a TV NOT equipped with
remote control:
2.1 Enter "SET Mode" (See Note 1)
2.2 Press Key momentarily
2.3 Press keys "1", "0", "2", "5"
(Indicator lamp should blink twice and
turn off. If indicator lamp just turns
off, the code has not been entered
correctly and the procedure should be
repeated beginning at Step A2.2.1.
2.4 The remote is now ready to control
your CATV converter box.
B. TV CODE PROGRAM PROCEDURE
1.1 Enter "SET Mode" (See Note 1)
1.2 Press the momentarily
1.3 Look up appropriate TV and enter
the first code ( for instance, for an
NEC TV depress keys "0", "1", "0")
1.4 Aim the rem^e at the TV and
depress the JQ| Key. If the TV
turns on (or off) the code is correct
and the remote is ready for use.
The remote is now ready for use.
If the TV does not respond, repeat
the procedure beginning with Step B.1.1
and enter the next code for that model
TV until the TV turns on (or off).
If the TV does not respond after all
codes are tried, use the procedure
"SCAN TV PROCEDURE".
SCAN TV PROCEDURE
1.1 Enter "SET Mode" (See Note 1)
1.2 Press IIQI Key
1.3 Press SLOWLY and repeat
pressing until TV turns on (or off).
It may require more than 100
key depressions to find the proper
code.
1.4 Press!
BATTERIES
Use two (2) AAA batteries
NOTE: If new batteries are replaced
within 5 minutes after the old are
removed, the program should be
retained and reprogramming will not
be required.
Indicator Lamp
Power
Keys
Number I
Keys
After determining the codes that
operate your devices, write the
codes in the spaces provided on the
back overlay for easy reference.
Pioneer
New Media
Te^., Inc. rmm
XXXXXXX137X