Figure 18 figure 19, Two level ~ compact models – Kenmore 808353 User Manual

Page 23

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

A Removal of Middle Spray Arm

1 Remove stainless steel cotter pin in tower end of pjaslic spray arm spindle underneath the black plastic supply

arm

2 The spray arm and spindle can now be lifted off the supply arm

B Removal of Upper Spray Arm Only

1 From below, in tub, remove two screws which hold spray arm and bearing assembly to plastic distributor

(See Figure IS )

2 The assembly wilt then drop loose If it is desired to remove the arm from the bearing assembly, the two

screws that hold them together are now accessible

'

NOTE

In Mid-1980 the design of the third spray arm was changed

The

spray arm Is removed by removing

the

center

mounting screw [See Figure 19]

ay

FIGURE 18

FIGURE 19

Two Level ~ Compact Models

The top spray arm water supply system on all 18" Ccompact) dishwashers is completely

externa!

of the wash chamber,

A hose from the back side of the pump housing runs behind the back center of the wash chamber (tub) up to the delivery

tube

To remove: (See Figure 20)

1. Disconnect power supply to dishwasher,

2

Loosen and remove clamp attaching delivery hose to pump housing

NOTE:

Water remaining in hose artd pump should

be caught in a bowl

3

Remove four W) screws that attach the delivery tube to the tub assembly.

4

Remove hose by pulling slowly through the opening in rear of tub.

Reverse procedure to reinstall and check for leaks and kinks.

20

Advertising