Figure 43 – Kenmore 808353 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5, Remove hose saddle
6
, Remove hoses.
7, Detach Intel hose and reattach it to a new coupler and drain hose assembly
Reinslail coupler and hose assembly in reverse order, Be certain routing is proper with no twists or kinks in hoses
Check connections for leaks and test movement of hoses in and out of cabinet
Adjustment of Hose Length,;
The length of the hose when fuliy extended is approximately A'
6
" to 5'. Should this appear short or an additional
inch or two be needed, you could take up any slack that may be available in the routing (Figure42), Be certain
however, that you do not kink or otherwise restrict the hoses..
B Hose and Coupler Assembly (IB" compact mode!)
Repiacemenl of fifi hose, drain hose and coupler. (See Figure 43).,
1.
Disconnect power supply..
2. Remove lop assembly,
3. Remove hose and power cord pocket,
4-, Remove saddle bracket,
5. Till dishwasher and disconnect hoses from valve and pump housing.
During re*assembiy, reverse procedure and piace saddle damp approximailey 50 Inches from the coupler end of the new
assembly on the drain hose and approximately 48 inches on fill hose.
fSTEP 5
FIGURE 43
4 3