Kenmore 808353 - Manual (Page 55)

If the second wash or'final rinse phase Is prolonged for an excessive amount of time, causing the water to become
hotter than necessary:
1, Check for too high calibration. (Follow same procedure as outlined on the previous page )
2, Check the thermostat circuit for correct wiring
3 Check to see that power is applied to one terminal of thermostat by the timer at the proper time.
4. Check the heating eiemertt
If 1 and 2 are satisfactory, a faulty thermostat is indicated and should be replaced.
CAUTION:
Care should be taken when installing a replacement thermostat so as not to place a ny
strain or pressure on the body of the thermostat. Note that the thermostat ts held m
position by a clamp on the wire leads.
c V nichufatheri hnth nortable and built-in are eauipped with sensing devices to Indicate to the user
Some Kenmore Dishwashers, both portaoie ana ouni m, ^ ^ "Cool."
the temperature of the water withm the machine. The water temperature will iaii witnm me ranges ut .
"Normal," or "Sanl" and will be indicated by lights on the console as shown m Figure 59.
TEMPERATURE INDICATOR LIGHT
■CYCLE indicator LENS
-SAN!
NORMAL
COOL
DRY TIME SELECTOR TJEMPERATURE DELAY
F I G U R E 5 9 ....
The "coot" ihermoslat (Figure 60)is a single pole single throw temperature controlled switch The "sam” thermostat
(Figure 61 ) is a single pole double throw switch.
FIGURE 60
52