Kenmore 808353 - Manual (Page 85)

C Hsdtsr T^SliliQ
Connect the dishwasher electrically- Remove the racks from the tiib. Advance the ^ fS'di’shL^s^e^on^and
cycle. If your dishwasher has a Power Miser Switch be sure tt is m the Hot position. Turn the dishwasher on and
allow it to operate for about 3 minutes,
Partially open the dishwasher door. The heating element should be glowing red around its circumference.
If the healinq element does not show evidence of heating, check voltage across the heater terminal, if Ime voltage
(5 read, it shows electrical power is reaching the element and a defective element is indicated.
If voltage is not present, check for an open circuit Refer to the schematic wiring diagram.
When inslalling a new element, make certain the tub mounting holes are cleaned of any
Zayruse new gaskets when inslalling a heating element. Remember to reconnect the ground wire to the heater
sheath.
D, Hot Dry “ Cool Dry Power Miser Switch
This feature gives the operator the option of a normal drying cycle with heal or the energy saving option of air drying
dishes without heat
1 NOW-biower models - Coo! Dry selection will cause the heater circuit to open at the comoletion of the final pump
^ ThruLr motor will reLin energized and will continue to run approKimately 26 minutes to the "Off"
position
2 Blower Model ~ Cool dry selection will cause the healer circuit to open as described for non-blower models In
models having blowers, however, the blower will continue to operate and circulate air within the dishwasher for
26 minutes The machine will then shut off.
Drying without heat will not be as effective as drying with heal Drying can be Improved by unlatching the door
at the completion of the cycle.
The Hot Dry-Cool Dry feature is one that has been requested by the consumer. Use of the cool dry feature will
result in considerable reduction in the electrical energy required to operate the dishwasher.
8 2