Kenmore 808353 - Manual (Page 94)

PROBLEM POSSIBLE CAUSE ACTION
Wetting agent liquid 1. Wetting agent cup ribs not against 1 Same as in No. 1 in previous
won't eject. door liner. problem.
2 Col! spring or "C" clip broken.
(Solenoid type.!
3. Solenoid defective.
4. Bi-metal release defective.
Wetting agent 1, Overfilling. 1. Follow instructions in the Owner's
dispensar leak Manual.
{Bi-metal release
type). 2. Bottle cracked. 2. Replace.
3„ Defective seal on stopper. ' 3. Replace stopper.
4. Dishwasher not level 4„ Level dishwasher.
Water Leaks
The source of a water leak is sometimes very djfficult to iocate. Before operating the dishwasher or attempting any repair,
disconnect the dishwasher from the electrical power source. Take off the door and access panel and look for water
"tracks," Be sure to check all the "tracks" and inspect the area which you suspect to be the source of the leak. Make
certain you trace the water tracks back to its origin. After making the repair, wipe away all water "tracks" and test
the machine again to verify your diagnosis and correction.
Identification of where the leak is located and what is causing the leak is the most difficult part of the problem. In some
cases, there may be more than one source for the leak.
If the leak cannot be located, make the following routine checks.
1. Check spray arm - make sure there is no opening anywhere along the crimped seam and/or the spray arm is not binding
on the pump housing. Be sure the spray arm nut is installed correctly.
2. Tighten all screws and bolts in interior of tub.
CAUTION: EKcessive tightening may crack porcelain.
3. Tighten water inlet port nut,
4. Check gasket for cuts or wrinkles Gasket should fit snugly against all sides of the tub. Pay particular attention to
the lower corners.
5. Check all hose connections.
6. Check water temperature. Follow the detergent manufacturers temperature recommendation. Water that is too cool
may cause sudsing,
7. Check detergent. (Must be fresh and must be for Dishwasher use only.)
8. Do not pre-rinse with regular dishwashing soap.
9. Follow loading instructions in owner's manual
Following the procedures outlined in points 1 through 9 should eliminate the source of the leak.
9 1