Sharp Atomic clock - Manual (Page 10)

TWO YEAR LIMITED WARRANTY
M.Z. Berger & Company warrants the original consumer
purchaser of this product that it shall be free of defects in
materials and workmanship for two years from the purchase
date of this product. Defects caused by tampering, improper
use, unauthorized modifications or repairs, immersion in water
or abuse are not covered by this warranty. If a defect covered
by this warranty occurs during the warranty period, wrap
your clock carefully and send it to the following address;
M.Z. Berger Service Center
29-76 Northern Boulevard
Long Island City, NY
11101-2224
You must include a proof of purchase, either the original
receipt of a photocopy and a check or money order for
USD19.99 to cover the cost of handling. Also include your
return address inside the package. M.Z. Berger & Company
will repair or replace the clock and return it to you. M.Z. Berger
& Company will not be liable for any loss or damage, including
incidental or consequential damages of any kind; from any
breach of warranty either expressed or implied relating to
the product. Since some states do not allow the exclusion
or limitation of incidental or consequential damages, this
limitation may not apply to you. This warranty gives you
specific rights, and you may have other rights that vary from state
to state.
SPC900
Printed in China
SHARP, registered in the U.S. Patent and Trademark Office
17
This device complies with Part 15 of the FCC Ruies.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning:
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate ratio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
18