Sharp VIEWCAM VL-WD650U - Manual (Page 110)

Appendix
\
Symptom Possible cause Suggested solution
C)
■o
о
Cannot play back, rewind
or fast forward tape. Position at beginning or end of
tape.
Rewind or fast forward tape to
desired point (p. 23).
£
u
(C
n
>t
Л
Video noise in image. Dirty video heads. Call for service (p. 96), or use a
commercially available video head
cleaning tape
(p. 92).
Q.
Old or worn tape. Use a new cassette.
a>
■D
о
£
Cannot delete image
on SmartMedia card. Write-protect seal is affixed to card.Remove write-protect seal (p. 89).
Image is delete-protected. Cancel the protection setting
(p. 80).
Ш
u
Cannot format
SmartMedia card. Write-protect seal is affixed to card.Remove write-protect seal (p. 89).
Cassette will not eject. Power source is not properly
connected.
Connect power source properly
(pp.10,11).
Battery pack is not charged. Charge battery pack sufficiently
(p. 9).
Camcorder is recording. Stop tape and try again (p. 20).
Viewfinder picture is
hard to see.
Viewfinder diopter is not properly
adjusted.
Adjust diopter (p. 18).
LCD monitor picture is
hard to see. Inappropriate picture adjustments. Adjust picture (p. 64).
15
G)
C
Cannot edit to con­
nected video equipment.
Audio/video or DV cable is not
properly connected.
Connect audio/video or DV cable
properly (pp. 65-67).
О Remote control does
not function. REMOTE menu item is set to
“OFF”. Set REMOTE menu item to “ON"
(pp. 43,44).
Remote control battery has run
down.
Replace remote control batteries
with new ones (p. 43).
Remote control used beyond
operating range.
Use remote control within operating
range
(p. 44).
Intense daylight falling on
camcorder remote sensor.
Protect remote sensor from
exposure to intense daylight (p. 44).
Obstacle between remote control
and camcorder remote sensor. Remove obstacle or use remote
control from different angle (p. 44).
Notes:
X • This unit is equipped with a microprocessor. Its performance couid be adverseiy affected by externai eiectrical
^ noise or interference. If this should happen, turn off the power and disconnect the unit from any power
g_ sources, including the lithium battery, etc. Then reconnect the power sources to resume operation,
g- »If the characters displayed in the viewfinder or on the LCD monitor appear to malfunction, disconnect the
" power source and remove the lithium battery, then reconnect the power source, insert the lithium battery, and
turn the power on again. The characters should be normal. Set the date and time, then resume operation.
95