Remaining recording time display, Remaining battery power display – Sharp VIEWCAM VL-WD650U User Manual

Page 37

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Remaining Recording Time
Display

When the camcorder is recording in TAPE­
CAMERA mode, an on-screen indicator
displays the approximate remaining tape time

in minutes.

During camera recording in TAPE-CAMERA

mode, press the MENU/DISPLAY button until

the remaining recording time indicator ap­

pears.

To turn off the indicator, press the MENU/

DISPLAY button again.

Notes:

• The remaining recording time indicator

appears 10 seconds after pressing the REC
START/STOP button to begin recording.

• The remaining recording time indicator only

shows the approximate time left. Also, it varies
slightly depending on the length of tape used.

(This function is based on the DVM60 tape

standard.)

When the remaining recording time reaches 1

minute, a warning indicator will appear.
Prepare a new cassette.

Warning indicator

Approx, remaining time

THE TAPE

ENDS SOON.

-JAPE END-

Less than 1 min.

CHANGE THE

CASSETTE.

(The tape has reached

4'

TAPE END

the end.)

Remaining Battery Power
Display

When using the camcorder with the battery

pack as the power source, you can turn on and

off the remaining battery power indicator by

pressing the MENU/DISPLAY button. If the
battery power becomes very low, a warning
indicator will appear. Replace the battery pack.

S’

(Green)

i

(Green)

\

i|

(Red)

BATTERY iS

TOO LOW.

Remaining battery

power indicator

y , J ^

-C5p-

y f % — 1

Warning indicator

o'

Notes:

• Use the remaining battery power indicator only

as an approximate indication.

• The remaining battery power indicator may

change to either a higher or lower level if you set

the Power switch to OFF and then back to

CAMERA or VCR.

• In cold environments, the red remaining battery

power indicator may appear sooner. The battery
pack, however, can be used until the warning
indicator appears.

• Use of the zoom functions when the warning

indicator is displayed may cause the camcorder

to suddenly lose power.

22

Advertising
This manual is related to the following products: