Sharp CD-ES99 - Manual (Page 15)

Setting the dock CD-ES900
CD-ES99
■O
In this example, the dock is set for the 12-hour (AM 12:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK/TIMER button.
3 Within 10 seconds, press the m « or ►►►N button to se­
lect "CLOCK", and press the MEMORY/SET button.
4
Press the -4« or ►► button to select 12-hour or 24-
hour display and then press the MEMORY/SET button.
“AM 12:00" .> The 12-hour display will appear.
(AM 12:00- PM 11:59)
"AM 0:00" ^ The 12-hour display will appear.
(AM 0:00- PM 11:59)
"0:00" The 24-hour display will appear.
(0:00 -23:59)
5
Press the K-4 -<-t or ►► W button to adjust the hour and then
press the MEMORY/SET button.
Press the W «or ►► button once to advance the time by 1
hour. Hold it down to advance continuously.
6 Press the l-M -44 or ►► button to adjust the minutes and
then press the MEMORY/SET button.
Press the K4 «or» »\ button once to advance the time by 1
minute. Hold it down to change the time in 5-minute intervals.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the CLOCK/TIMER button.
The time display will appear for about 10 seconds.
[When the power is on]
Press the CLOCK/TIMER button.
Within 10 seconds, press the H44 « or»»\ button to display the time.
The time display will appear for about 10 seconds.
Note:
The "CLOCK" will appear or time will flash to confirm the time dis­
play when the AC power supply is restored after a power failure or
unplugging the unit. If incorrect, readjust the clock as follows.
To readjust the ciock:
Perform "Setting the clock" from step 1. If the "CLOCK" is not
appear in step 3, step 4 (for selecting the 12-hour or 24-hour dis­
play) will be skipped.
To change the 12-hour or 24-hour display:
1 Clear all the programmed contents. [Refer to "Clearing ail the
memory (reset)" on page 33 for details.]
2 Perform "Setting the clock" from step 1.
Note:
The dock can also be set with the remote control.
15