Sharp CD-ES99 - Manual (Page 26)

CD-ES900
CD-ES99
Recording on a cassette tape (continued)
Recording from several CDs continuously:
1 Perform steps 1 - 5 in "Recording from a CD (CDs)" on page 25.
2 Within 5 seconds, press the ► / .
To perform programmed recording:
1 Program discs and tracks. (See page 20.)
2 Press the
Oil
button.
3 Press the
To stop recording:
Press the ■ button.
The CD and tape wii! stop.
■ Recording from the radio
1
Tune in to the desired station. (See page 21.)
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the
Oil
button.
Recording will be paused.
W ' ' C
4 Press the ► / < • button to start recording.
To interrupt recording:
Press the
Oil
button.
To resume recording, press the ► / <^ button.
To stop recording:
Press the ■ button.
Note:
If you hear a whistling noise while recording an AM station, move
the AM loop antenna.
■ Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1 Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette com­
partment. Insert a blank tape
into the TAPE 2 cassette com­
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1 — 2) button until "TAPE 1" appears on
the display.
4
Press the •!! button.
Recording will be paused.
5
Press the ► /' : button to start dubbing.
To stop dubbing:
Press the ■ button.
TAPE 1 and TAPE 2 will simultaneously stop.
■ Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette compart­
ment with the side to be erased facing toward you.
2 Press the TAPE ( 1 — 2 ) button until "TAPE 2" appears on the dis­
play.
3 Press the ®li button.
4 Press the ► /' • button to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
26