Charging the battery pack, Extending battery pack life – Sharp VIEWCAM VL-NZ50U User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Charging the Battery

Pack

1

Attach the battery pack on the
camcorder, and make sure that the

Power switch is set to OFF.

Plug the AC adapter into a power outlet

(i'i)), then insert the DC plug into the DC

input jack ((

2

)).

• The charge indicator lights up.

• The charge indicator turns off when the

battery is charged.

3

Remove the DC plug from the DC input

jack, then remove the AC adapter from

the power outlet.

Charging time and maximum continu­
ous recording and playback times

Bslkry

Chririjirii; Max. canliniiiiiis Max. cMinliniimis

iiiiuk

linu

recorttirig tliiteiiilaybiiak tiiMu

Rl '1

2iir

iiii. Suniiii.

liir. aoniiii.

BT-L445

approK.

3hr. aomin.

approx.

3hr.

approx.

3hr.

Notes:
• Charge the battery pack between 50°F and

86°F (10°C and 30°C). The battery pack may

not charge properly at temperatures too low

or too high.

• The battery pack and charger become warm

during charging. This is not a malfunction.

• Using the zoom (see page 17) and other

functions or turning the power on and off
frequently will increase power consumption.

This may result in a decrease in the actual
recording time compared to the maximum
continuous recording time listed above.

• The charging time and recording time may

vary depending on the ambient temperature
and the condition of the battery pack.

• See page 53 for more information on using the

battery pack.

Caution:

• Charge only SHARP mode! BT-L225 or BT-L445

battery packs. Other types of battery packs may
burst, causing personal injury and damage.

Extending battery pack life

Even when the battery pack is not used, the

capacity of the battery pack will naturally
deteriorate over time. To limit the deterioration

of the capacity, it is recommended to perform
the following procedure at least once every six

months:

CT. Fully charge the battery pack.

(OAttach the battery pack to the camcorder,

and set the Power switch to CAMERA

v/ithout inserting a cassette. Allow the

battery power to fully discharge by leaving
it on the camcorder until the camcorder
power automatically turns off.

ti Remove the battery pack and store it

between 50°F and 58^F (10“C and 20^C).

3

1

Advertising