Editing with the dv terminal (ieee1394), To record from video equipment, To stop recording – Sharp VIEWCAM VL-NZ50U User Manual
Page 57: Cutting unwanted sequences
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Editing with the DV
Terminal (IEEE1394)
This camcorder enables you to perform digital
video editing. Connect the camcorder to video
equipment with a DV terminal using a commer
cially available DV cable. A DV cable is able to
transfer all dubbing signals including video
and audio.
To Record from Video Equip
ment
1
Set the camcorder to VCR mode, and
insert a Mini DV cassette.
2
Begin playback on the video equipment
connected to the camcorder.
• Check the camcorder screen to see it
the picture is properly received.
To Record to Video Equipment 3
See “Cutting Unwanted Sequences” on page
43, using the video equipment as the recording
source.
Note:
• Make sure that the video equipment to which
you are recording can input dubbing signals via
the DV terminal.
Press the REC START/STOP button on
the camcorder.
• The camcorder enters Recording
Standby mode.
4
Press
A
on the Operation button to
begin recording.
To stop recording
Press v' on the Operation button.
Cutting Unwanted Sequences
1
Press
A
to pause recording when the
source tape reaches the beginning of
the sequence to be cut.
2
Press
A
to resume recording when the
source tape reaches the end of the
sequence to be cut.
Notes:
• Make sure that the video equipment from which
you are recording can output dubbing signals
via the DV terminal.
• If the video equipment is not set to playback
mode or the DV cable is not properly connected,
“NO SIGNAL" is displayed on the camcorder
screen.
• If no picture or sound is input to the camcorder
even if the DV cable Is properly connected and
you are playing back the source media from the
video equipment, set the Power switch on the
camcorder to OFF and then back to VCR, or
disconnect the DV cable and connect it again.
• If a digital video recording with a copyright
protection signal is used as the playback source,
“COPYRIGHT PROTECTED." appears on the
camcorder monitor and the recording function is
disabled (see page 51).
• When displaying the playback picture on the
recording equipment, you may find black bands
around the image. This is caused by the
differences of the image display sizes.
• You cannot output the picture playing back from
the DV terminal to an external monitor.
3
a.
=
s
44