Canon DIGITAL VIDEO CAMCORDER MD130 - Manual (Page 32)

Playback 32
• The tape stops at or near the zero
mark,
disappears and the correct
time code will be displayed again.
NOTES
If there are blank sections between recordings,
the zero set memory may not work correctly.
Locating the End of the Last Scene
After playing back a tape, use this
function to locate the end of the last
scene recorded in order to continue
recording from that point.
POINTS TO CHECK
Stop the playback before using this
function.
1
Press .
2
Select ( ) [ END SEARCH] and
press ( ).
3
Select ( ) [EXECUTE] and press
( ).
• “END SEARCH” appears.
• The camcorder rewinds/fast forwards
the tape, plays back the last few
seconds of the recording and stops the
tape.
• To cancel the search push the
joystick (
) towards .
NOTES
End search cannot be used once you remove
the cassette.
If there are blank sections between
recordings, the end search may not work
correctly.
You cannot use the end search to locate the
end of a scene that was audio dubbed.
Locating Scenes by Recording Date
You can locate the change of the date/
time zone with the date search function.
Press or on the wireless
controller.
• Press more than once to search for
further date changes (up to 10 times).
• To cancel the search press
.
NOTES
Recordings shorter than 1 minute per date/
time zone cannot be located with this function.
Date search may not function if the data code
is not correctly displayed.
FUNC.
( 22)
FUNC.
STOP