BRP DS70 - Manual (Page 109)

FUEL SYSTEM
Throttle Cable Inspection
Check throttle lever free-play, adjust if
necessary.
If correct adjustment is unattainable,
see an authorized Can-Am dealer.
Inspect throttle cable for excessive
wear, kinking or fraying. Ensure cable
moves freely.
Replace throttle cable if any signs of
wear, fraying or other damage are
found.
Lubricate cable using silicone lubricant
(P/N 293 600 041) to reduce prema-
ture wear and to ensure proper move-
ment of the cable.
ƽ
WARNING
Always use a silicone-based lubri-
cant. Using another lubricant (like
a water-based
lubricant) could
cause the throttle lever/cable stick-
ing or stiffness.
Throttle Lever Adjustment
The normal throttle free-play is 5 to
10 mm (3/16 to 13/32 in).
vmo2008-020-003_b
TYPICAL — NORMAL FREE-PLAY
1. Throttle lever
A. 5 to 10 mm (3/16 to 13/32 in)
To adjust cable, slide rubber protector
back to expose throttle cable adjuster.
vmo2008-008-028_a
1. Rubber protector
Loosen locking nut and turn the ad-
juster to get proper adjustment.
NOTE: Measure throttle free play at
the tip of throttle lever.
Tighten locking nut and reinstall pro-
tector.
vmo2008-008-027_a
1. Lock nut
2. Adjuster
Speed Limiter Adjustment
This vehicle is equipped with an ad-
justable speed limiter.
Using the appropriate tools, it is pos-
sible to increase or decrease engine
speed by modifying speed limiter
screw position.
_____________________
107