BRP DS70 - Manual (Page 115)

V06H06Y
FREE-PLAY: 44 TO 57 MM (1-3/4 TO 2-1/4 IN)
When properly adjusted, tighten chain
adjuster lock nut.
Then, tighten drive axle locking bolts
to 69 N•m (51 lbf•ft).
Drive Chain Roller
Inspection
Inspect the drive chain roller around
swing arm pivot member for exces-
sive wear and damage.
Replace if
necessary.
vmo2008-008-048_a
1. Drive chain roller
Sprocket and Pinion
Inspection
Check the sprocket axle and pinion for
distortion. Replace if necessary.
V02H02Y
1
2
1. Good
2. Replace
CAUTION: Replace chain, sprocket
axle and pinion together to prevent
rapid chain and sprocket wear. In-
stall a new retaining ring each time
the pinion is removed.
Wheels Removal/
Condition
Occasionally, wheel bolts should be
removed to apply anti-seize lubricant
to ease future removal. This is particu-
larly important when vehicle is used in
salt-water environment or in mud. Re-
move one nut at a time, lubricate then
retorque.
Wheels Removal
Loosen bolts then lift vehicle. Place a
support under vehicle. Remove bolts
then remove wheel.
At installation, it is recommended
to apply anti-seize lubricant on bolts
threads.
Gently tighten bolts in a
criss-cross sequence then apply a fi-
nal torque.
WHEEL NUTS TORQUE
Front 71 N•m (52 lbf•ft)
Rear 120 N•m (89 lbf•ft)
_____________________
113