BRP DS70 - Manual (Page 118)

BRAKES
Inspection (hydraulic)
DS90 X
ƽ
WARNING
The brake fluid replacement or
brake system maintenance and re-
pairs should be performed by an
authorized Can-Am dealer.
The braking system is an hydraulic
type and no adjustment is required.
Check the following to keep the
brakes in a good operating condition:
– brake fluid level
– brake system for fluid leaks
– brake for spongy feel
– brake cleanliness
– brake discs for excessive wear and
surface condition
– brake pads for wear, damage or
looseness.
Have your authorized Can-Am dealer
inspect brake pads for wear or dam-
age.
BRAKE PAD
MINIMUM
THICKNESS
1 mm (.0394 in)
See your authorized Can-Am dealer if
a problem is detected concerning the
brake system.
Inspection (mechanical)
All Models except DS90 X
ƽ
WARNING
Any brake system repair should
be performed by an authorized
Can-Am Dealer.
Check brake levers free-play, adjust if
necessary.
Check for levers operation, they
should move freely and have a firm
feeling when brakes are applied.
If correct adjustment is unattainable,
see an authorized Can-Am dealer.
Inspect cables for excessive wear,
kinking or fraying.
Replace any cable that show signs of
wear, fraying or other damage.
Lubricate cables using silicone lubri-
cant (P/N 293 600 041) to reduce
premature wear and to ensure proper
movement of the cable.
ƽ
WARNING
Always use a silicone-based lubri-
cant. Using another lubricant (like
a water-based
lubricant) could
cause the brake cables sticking or
stiffness.
Have your authorized Can-Am dealer
inspect brake shoe for wear or dam-
age.
BRAKE SHOE MINIMUM THICKNESS
Front 1.5 mm (0.06 in)
Rear 1.5 mm (0.06 in)
See your authorized Can-Am dealer if
a problem is detected concerning the
brake system.
Front Brake Cable
Adjustment
All Models except DS90 X
Fully tighten all adjustment screws of
brake cables.
116
_____________________