BRP DS70 - Manual (Page 74)

9) Ignition Switch
Key-operated, 2-position switch: OFF
and ON.
vmo2008-008-012_a
IGNITION SWITCH
1. OFF position
2. ON position
Insert key in switch and turn to ON
position. To remove key, turn key to
OFF position then pull it out.
NOTE: While engine can be stopped
by turning ignition key to OFF posi-
tion, we recommend the engine be
stopped by the engine stop switch.
Always turn ignition switch to OFF po-
sition after engine has been stopped.
10) Fuel Tank Cap
ƽ
WARNING
Do not allow children to put fuel in
the vehicle.
Unscrew to fill up tank then fully tight-
en.
NOTE: Refer to FUELING PROCE-
DURE in LIQUIDS section for proper
fueling procedure.
ƽ
WARNING
Always stop engine before refu-
eling. Open cap slowly. If a dif-
ferential pressure condition is no-
ticed (whistling sound heard when
loosening fuel tank cap) have ve-
hicle inspected and/or repaired
before further operation. Fuel is
flammable and explosive. Never
use an open flame to check fuel
level. Never smoke or allow flame
or spark in vicinity. Always work
in a well-ventilated area. Never
top off the fuel tank before plac-
ing the vehicle in a warm area.
As temperature increases, fuel ex-
pands and may overflow. Always
wipe off any fuel spillage from the
vehicle.
vmo2008-020-015_a
TYPICAL
1. Fuel tank cap
11) Fuel Valve
This is a 3-position rotary valve: OFF,
ON, RES. Rotate the tab to align its
pointer with ON, OFF or RES.
72
______________________