Craftsman 919.167461 User Manual

Page 14

Advertising
background image

14- ENG

D28071

How to Start:

1.

Turn the On/Auto/Off lever to
"AUTO" and allow tank pressure
to build. Motor will stop when
tank pressure reaches "cut-out"
pressure.

2.

Pull the regulator knob out and
turn clockwise to increase pres-
sure. When the desired pressure
is reached push knob in to lock
in place. The compressor is
ready for use.

NOTE: Always operate the air com-
pressor in well-ventilated areas free
of gasoline or other combustible
vapors. If the compressor is being
used to operate a sprayer DO NOT
place near the spray area.

Before Each Start-Up:

1.

Place On/Auto/Off lever to
"OFF".

2.

Pull regulator knob out, turn
counter-clockwise until it stops.
Push knob in to lock in place.

3.

Attach hose and accessories.
NOTE: The hose or accessory
will require a quick connect plug
if the air outlet is equipped with a
quick connect.

5.

Run the compressor for 15 min-
utes. Make sure the drain valve is
open and there is minimal air
pressure build-up in tank.

6.

After 15 minutes, close the drain
valve (clockwise). The air receiver
will fill to "cut-out" pressure and
the motor will stop.

The compressor is now ready for use.

Risk of Bursting.

Too much air

pressure causes a hazardous risk
of bursting. Check the manufactur-
er’s maximum pressure rating for
air tools and accessories. The reg-
ulator outlet pressure must never
exceed the maximum pressure
rating.

Advertising