Crown Verity Gas Grill - Manual

24 Wildwood Drive, Essex Junction, Vermont 05452 Phone: (802)878-6190 Fax: (802)878-6190
Website: www.crownverity.com Email: [email protected]
Crown Verity Gas Grill
Operating Instructions
SET-UP:
1. Prior to lighting the grill always fill the pans under the unit with water. You must
keep water in the pans at all times while in use. Water will evaporate while
cooking so refill the water pans with water during cooking if needed.
LIGHTING INSTRUCTIONS:
1. Connect the gas hose(s) to the propane tanks or gas outlet. Make sure the green
nut on the gas hose/regulator is securely tightened to the tank if connecting to
propane tanks.
2. Open all lids on the grill.
3. Ensure that all valve knobs are in the OFF position (clockwise).
4. Turn on the gas supply valves slowly. WAIT 15 SECONDS. (Do not crack open
tank valve like you would a water faucet. Open valve on tanks slowly.)
5. Turn the lighter tube (pilot – red knob) valve to the ON position. (Note: two lighter
tubes are on this unit - one for the left side and one for the right side).
Insert a long stick type lighter into the holes provided on each side of the front of
the grill. You need to light both sides of the unit.
6. Visually check to ensure the lighter tube is burning.
Once the lighter tube has been lit the main burners will ignite off of the lighter
tube when they are turned on. (Push in black knobs and turn to “high”) The unlit
burners will then light automatically.
7. Visually check to ensure that all burners that are intended to be ON are lit.
8. Adjust individual burners as desired.